![]() ![]() I just started with the Hrd, and the first problems begin. ![]() Make sure you do NOT do his before step 3 above!Ħ) Find out the correct port in your Windows Device Manager to use by looking for the "Microbit RRC Virtual COM Port (COM2)"ħ) Set your software to use the this COM port on your PC at -N. ![]() You don't need the problem for this, but this installs the correct drivers on your PC.Ĥ) Change the COM2 serial settings of the control-RRC to mode-4, 4800 baud, data bits 8, stop bits 1, "use USB Com Port as COM2" to "Yes" and submit/apply changes.ĥ) Plug a USB cable between your PC and control-RRC. This rate keeps traffic over the internet to a minimum and faster is not necessary for CAT.Ģ) Change the COM2 serial settings of the radio-RRC to mode-4, 4800 baud, data bits 8, stop bits 1 and submit/apply changes.ģ) Change the COM2 serial settings of the control-RRC to mode-4, 4800 baud, data bits 8, stop bits 1 and submit/apply changes.Ĥ) Plug a serial cable in between your PC and the control-RRC COM2ĥ) Set your software to use the correct COM port on your PC at -Nģ) Install the Microbit Setup Manager if you already haven't. IMPORTANT: In both scenarios, you MUST first install a standard serial cable between the TS-480 body and COM2 of the radio RRC!ġ) Change the CAT rate on the TS-480 to 4800 baud (menu 56). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |